Micronics PCI/ISA System Board D6-IN Manuel d'utilisateur télécharger pdf (Page 24)

D6-IN System Board Manual

Installing a CPU

The D6-IN is designed to support a variety of Pentium

Pro processors. Follow the steps below to install a proces-

sor:

1. Turn off the computer and remove its cover.

2. Locate the ZIF socket illustrated in Figure 2-1.

3. Lift the lever of the socket.

4. Locate pin 1 on the processor and pin 1 on the socket

(refer to Figure 2-1). Gently place the processor into

the socket, making sure pin 1 on the processor and

pin 1 on the socket are aligned.

5. Push the lever down until it locks into place.

6. Make sure the speed selection jumpers are set cor-

rectly (refer to Chapter 2 - Jumper Settings).

WARNING: Pentium Pro processors require a heat-sink

with a cooling fan. Failure to provide adequate cooling of the

processor may seriously affect system performance or cause

permanent damage to the processor.

Chapter 3: Installing the D6-IN

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 70 71

Pas de commentaire

Micronics PCI/ISA System Board D6-IN Manuel d'utilisateur Page 24