Micronics PCI/ISA System Board D6-IN Manuel d'utilisateur télécharger pdf (Page 24)

The BIOS Setup Utility

4-1

4The BIOS Setup Utility

Configuration

After the M6Pi system board and all hardware is installed, the system is

ready for configuration. Before turning on the computer, make sure all

cables are correctly connected and all jumpers are correctly set.

It is recommended you keep the computer cover off the first time you

boot the system. This will make it easier to correct any difficulties that

might arise.

Initial Boot Up

Power up the M6Pi. If the system does not properly boot, check all

your cables and peripherals for bad connections. You may also get beep

codes or error messages. If this occurs, consult Appendices A and/or B

for a guide to possible solutions.

After the system properly boots, it is ready to be configured. The

following pages explain the proper procedures for BIOS configuration.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 50 51

Pas de commentaire

Micronics PCI/ISA System Board D6-IN Manuel d'utilisateur Page 24